Acudor Electric Actuation Roof Hatches are designed to provide convenient, economical access to the roof of a building with the ease of automation. By adding an electric actuator, our hatch can be opened and closed remotely. This feature is available on small ladder access hatches, and more importantly on larger equipment hatches, which are typically heavy and difficult to operate.
Door Size W x H
* Includes LTL Freight (continental US only, residential delivery at additional charge. Additional fees such as lift gate or jobsite delivery are not included and will have to be collected if applicable)
Lead time: 4 weeks, ships factory direct and is not returnable
12V/24V DC Electrical Actuator.
Suitable for mains supply AC 120V/60Hz or 230V/50Hz
Can open to any angle up to 80 degrees max
Optional battery back-up
Synchronized operation for large sizes
Stainless Steel Hardware
Curb Mounted Units
Curb pitch corrected for sloped roof
Cover: Double-skin construction (“in box type design”) with 1" cellulose insulation and a continuous EPDM foam
weather/draft seal gasket that is attached to the inside of
cover to provide a flush, tight fit. Designed to support a
live load of 40lbs./sq. ft., the cover is 14 gauge galvanized
steel with a 22 gauge galvanized steel inside liner
Curb: 14 gauge galvanized steel with 1" thick fiberboard
roof insulation at curb exterior. Curb is 12" high, with
3.375" wide bottom flange and pre-drilled mounting holes
Opening: Convenient electric actuation with options of Push
Button Switch, Key Switch and/or Remote Control. Can be kept
open at any angle for ventilation. Single covers with more than
one actuator operate on synchronous mode. Hatches with
more than one cover have at least two actuators which need
to be operated in sequence. Optional battery back-up can be
provided for emergency exits to ensure power supply in case
of power outage. Control Box keeps the batteries charged.
Door Latch: Self Locking feature of Electric Actuator replaces
need for conventional locks in standard designs. Additional
locking arrangements available upon request.
Finish: Material is prepared with an iron phosphate wash,
followed by a rust inhibiting primer, and then a baked on
polyester enamel paint.